WEEK 9

PROJECT DESIGN REVIEW

Assalamualaikum.

This post is for progresses made on the week 9 of completing this project.

For this post, i would like to shows my project design review. For the design includes all the main part of project such as the sensor, electronic system unit and microcontroller. The objectives for this design is to review the available part to used for my final year project prototype also to purpose the actual design for real car steering.  

PROJECT DESIGN REVIEW

WEEK 8

BLOCK DIAGRAM 

The block diagram shows that project have three main part. For the first part is input part. In this part the sensor will be the main component to get the reading from the human skin resistance. For this part is the process the input will be reading before send it into microprocessor. The second part is the micro-controller part, which is the controller for the data input from the sensor before give the real output. In this part include the amplifier for the input sensor, because the sometimes the reading from the sensor very small and cannot amplified with microprocessor part. For the last part is the output for this project. In the planning the output will shows in dashboard. In this part the Electronic car unit is the main component to success this project. Its because the Electronic car unit functions to detect the output from the microprocessor before give the response (alert message). The Electronic car unit also functions send the message to the third party such as the hospital, police station and medical center. This all is quick review for this project. 

Thank You 

WEEK 7

METHODOLOGY

This is the block diagram of my project after discussing with my supervisor.The hardware (project design) need to be configured to allow all the process happened. Start will be doing the literature review about all related in my project. Furthermore, is about the Galvanic Skin Resistor Sensor (implant to wheel steering) detecting the human body process and then the process will decide using arduino/microprocessor .If on the arduino/microprocessor communicated to do the next process, it will be proceed to Electronic Car Unit to next process.Finally for my output the is about the signal maybe implant to dashboard. The signal can be the process to slow down the car besides send the massage to 3rd party such as the hospitals or police stations.   

Thank you

WEEK 6

ELECTRONIC CONTROL UNIT

What does the ECU do?

The ECU is responsible for monitoring all aspects of engine operation, making adjustments based on driver input, and more. It reads the amount of airflow entering the engine to adjust the throttle and it controls the Check Engine Light (at least partially). It also manages ignition timing, idle speed, variable valve timing, electronic valve control and more. Information is sent to the ECU from sensors located throughout the engine bay that do everything from measuring coolant temperature to camshaft position. In short, the ECU has a huge impact on your vehicle’s operation, including everything from the available power to emissions control. Enjoy the video for more details informations. 

Thank you.